2017 Ford Territory Pricing and Specs

It shouldn't matter how old a safety recall is, it's a safety issue, so it needs to be fixed. That's why there's no actual time limit for these repairs to be made.

Here's the official response from the Department of Infrastructure: “There are no time limits applied to vehicle recalls by the department. It is expected that if a vehicle is presented for an older recall, the manufacturer will repair it as per the original recall notice”.

The potential spanner in the works there would be if the manufacturer is no longer represented in Australia or, if the parts required were no longer being made or otherwise available. In any case, this would definitely be worth chasing up with Ford as the recall was for potentially faulty brake lines which could cause a catastrophic failure with horrendous results.

Clearly something is wrong here because wheel bearings should have a much monger lifespan than 12 months. I'd start by checking that the wheel alignment (yes, rear wheels need to be aligned, too) is correct and not putting weird stresses and strains on suspension components which could include the bearings. While you're at it, check the condition of the suspension bushes, too, as these can also allow alignment to become a problem.

Do you tow heavy loads with the car? This can also place huge stress on things like bearings and cause them to wear faster. Also, who replaced the previous set 12 months ago? Can you be sure they didn't over-tighten the new bearings, causing them to wear faster? Were the new bearings a good quality or a cheap replacement? Has the supplier of the bearings received the same complaint from other customers, suggesting a bad batch of bearings could be the cause? I've personally seen a brand new wheel bearing collapse in under 20km because the surfaces had not been hardened properly during the manufacturing process.

Finally, given the wild weather this continent has been experiencing, have you driven through flood-waters at any stage. Unlike fresh water, flood-water is often full of tiny silt particles which get into the bearing and then act as griding paste, causing the bearing to fail super fast.

If you can't find the dipstick for the automatic transmission, there might be a very simple explanation: It doesn't have one. Many Fords from this era were not fitted with dipsticks, so checking the level is done from underneath the car via the a threaded plug. Not so easy to do at home. The transmission is a sealed system, and any drop in level indicates a problem that needs to be fixed. So the level is worth keeping an eye on, even if that's not so easy to do in cars like this one.

Theories for the dipstick deletion include preventing owners from over-filling the transmission (easier than you might think, since the transmission temperature when you check it is critical) as well as not giving owners the opportunity to top-up their transmission with the wrong type or grade of fluid.

At some point though you have to imagine that cost-cutting also came into the decision.