1979 Holden HZ Pricing and Specs

The first thing to do is check the fluid level in the transmission. Problems like this are often caused by a low fluid level, so that’s where to start. The problem then is that the Captiva’s transmission doesn’t have a conventional dipstick, so the level is checked by getting the vehicle up to operating temperature and then removing the fill bung (on the transmission next to the left-hand driveshaft. Obviously, you need to car off the ground to do this.

If a little fluid drips out of the fill bung when you remove it, the fluid level is correct. If not, you need to add fluid until it does start to drip back out. If the transmission is low on fluid, you’re also dealing with a leak, because this is a sealed system and should not require top-ups.

Don’t be tempted to continue driving the vehicle as it is, as the fluid not only provides the drive for the transmission, it also lubricates the moving parts. So operating it with a low fluid level can cause permanent damage to the unit.

This is very possibly a fault with the power supply to the fuel pump rather than the pump itself. The clue is that the fuel gauge started playing games just before the engine shut down. The fuel gauge is controlled by the sender which is usually in the tank with the pump. They’re often supplied power by the same wiring. So any problem with the power to the fuel pump would also possibly show up as a fuel gauge that’s making strange movements.

Start by checking the power supply to the pump, but don’t rule out a poor earth somewhere in there as well. Even though the fuse is okay, if the power wire or earth wire is loose/corroded/faulty/dirty/short-circuiting, then you may have found the problem.

Any remedy can only be suggested once you know what’s causing the problem. The first step, then, is to have the car scanned to see if there’s a problem the on-board computer has identified and logged. Once you have that information, you are a lot closer to knowing what to replace.

Logic suggests that an engine that runs roughly when it’s cold might be running lean. If that’s the case, it could be caused by many things including worn injectors, a lazy fuel pump or even a temperature sensor that is not telling the computer that controls these things that the coolant temperature is low and the engine needs more fuel to compensate. Then, once the engine has warmed up, the fuel-air mixture is correct and the engine settles down and runs properly. That said, 30km is a long time for the engine to take to warm up.

You could spend lots of time and money replacing the wrong bits here, so a scan is definitely the way to proceed.