Holden Commodore 2013 Problems

It was quite a common, and rather expensive issue when the Alloytec V6 was first released. Holden made a change to the chain in May 2007, which was claimed to have fixed the problem. I wouldn’t be put off buying a VF.

Yes, there’s no reason to be concerned about buying a Commodore of that age and kilometres.

If you believe they have appeared while the car was garaged you have to look at the possibility of something, or someone, rubbing against the car. It could be while they're moving past it, perhaps carrying something that's rubbed up against the paint. If you cover the car while it's garaged it could be the cover rubbing on the paint, perhaps due to wind blowing through the garage.

A Holden dealer, or an auto electrician should be able to sort it out for you.

They are probably blocked. Clean the nozzles out and make sure they are clear and flowing freely.

The VF Commodore is the best-ever Australian car and my pick. It gets a Big Tick. Neither will give you problems with servicing or parts suppies, even after the local factories close.

The Commodore is not affected by the Takata airbag recall.

Presumably the car makes this noise when you hit a bump or undulation. The Commodore’s front end is not particularly complex and is, in fact, a pretty standard MacPherson strut set-up.

With that in mind, there are only so many things that could cause the front end to bang or rattle, including a worn ball-joint, tie-rod end, or suspension bush. But don’t forget about the bushes in the steering rack, too, as these can contribute to a noise from the front end.

If all the suspension checks out, then you need to go a bit deeper into things like the cross-member mounts, engine mounts and even wheel bearings. Any wear or play in these components will cause a clunk in the right circumstance.

If none of that helps then you need to look beyond the suspension and into areas like a loose battery tray in the engine bay or even a loose piece of trim or sheet metal somewhere on the car. Exhaust heat shields are prime candidates for this, as are the metal shields at the back of each brake disc.