Are you having problems with your Holden Commodore? Let our team of motoring experts keep you up to date with all of the latest Holden Commodore issues & faults. We have gathered all of the most frequently asked questions and problems relating to the Holden Commodore in one spot to help you decide if it's a smart buy.
Show all
It’s probably an ignition issue so start by checking the spark plugs and leads, and perhaps replace them if they haven’t been replaced in a while.
If it just stops without any warning then I would think it's electrical and I would be checking the ECU and sensors that send it signals. Particularly check the crank angle sensor. If it were a fuel problem I would expect to get a warning, such as the engine going off song like it was starving for fuel before stopping.
Have an experienced engine mechanic listen to the engine on a cold start to determine where the noise is coming from. They should be able to tell if it is valve lifters, or perhaps piston slap, which is probably what it is.
Turning it off and on again reboots the computer, so it could be a fault with the computer or one of the sensors feeding information to it. Have a mechanic check the system for faults.
The important thing about where the needle sits is not so much where it sits on the scale, but that it’s always in that position. In other words you need to be concerned if it suddenly starts to sit in a different position to normal. I wouldn’t expect the needle to move much going up or down hills, normally they stay pretty much in the same position. Check that the thermostat is the correct one, and that it’s not stuck.
The fuel is measured from the injector’s duty cycle. It’s basically the fuel flow rate of the injector by the time the injector is open.
Take it to a reputable mechanic and have them thoroughly check it, in particular they should check the crank angle sensor.
It's odd that there's such a disparity between steady-state highway driving and round town use. If the performance has dropped off I would be checking things like the exhaust backpressure, which might show up a blocked or partially blocked catalytic converter; if the performance hasn't altered look at the oxygen sensors.
There is no Holden recommendation, as far as the company is concerned the transmission has been filled for life in the factory and needs no further servicing. The trade has a different view, however, and generally recommends an oil change service every year, and a major service, which would flush the transmission every two years. There’s no hard and fast rule, it comes down to common sense. In your case, at least get the oil and filter changed.