Are you having problems with your Holden? Let our team of motoring experts keep you up to date with all of the latest Holden issues & faults. We have gathered all of the most frequently asked questions and problems relating to the Holden in one spot to help you decide if it's a smart buy.
Show all
I CAN'T really give you a definitive answer because many factors can affect your decision. If you buy a new smaller car, the Fiesta, you have to be sure it will be big enough to transport your family. You will also suffer the depreciation that affects all new cars in the first year of ownership, but you will have the new-car smell and the coverage of the full warranty. If you buy a secondhand car you run the risk of having problems simply because it has been on the road for a time before you buy it. For me, the big advantage is you can get into something that is bigger and better equipped for the same money.
YOUR problem is a common one with the VS Commodore. Geoff Clay of CPA Automatic Transmissions says your problem was most likely caused by wear in the auto trans valve body, which results in a loss of oil pressure and increased slippage in the torque converter, which leads to your problem when under the load of towing. It would have happened whether you were in third or Drive. His recommendation is to tow in Drive as you were doing. The problem is a result of Holden changing from a cast-iron valve body to a die-cast one in the VS models.
THE dealer can't tell you where to have your car serviced. That contravenes the Trade Practices Act. But you must ensure your car is serviced according to the recommended servicing procedures and your service book must be stamped by the servicing agent. If you decide to use someone other than the dealer, you face the prospect of having to convince the dealer your car has been serviced correctly if you have a problem. Service intervals are specified in time and kilometres. Most servicing is done on the kilometres travelled, but the time intervals are included for those who accumulate kilometres more slowly.
ROTATING your tyres evens out the wear on all tyres and you get greater mileage from the set instead of wearing out the rears and being left with half-worn fronts. It's unusual to wear out the front tyres before the rear ones. In your case, running the higher inflation pressure might be the key to the wear pattern.
HAVE you switched fuel recently? A change of fuel can have the effect you complain of. Of course, it's worth checking the basics to make sure the engine management system is doing what it's meant to be doing, particularly during the cold phase.
AT that sort of mileage the fuel injectors could need cleaning. Dirty injectors can cause the sort of problems you describe -- rough running, stalling and misfiring. Have your mechanic check if that is the problem.
THERE are several ways to arrive at a selling price. Start by checking the Red Book and Glass's Guide websites, where you'll find price ranges. You might not be able to find the exact model listed, but the prices given for a similar model from the same year will still be a good guide to the value. From there you take into account the overall condition of the vehicle and the odometer reading. On the information I have I would think a price of $3000-$3500 would be close to the mark. There's not a lot of difference between capital cities, but you might get a better price in the bush.
BEING a sport model, the SS is sought after, particularly if in good condition. An average SS would now have well over 200,000km on the odometer and would be valued at $10,000 to $12,000. Yours has relatively low mileage, and if in good condition could be worth $15,000 if sold privately. Trading it in on a new car, you would get about $8000. You say you like driving it, so why sell it?
AFTER thoroughly checking LPG kits and fitters, Holden has approved an LPG kit and certified fitters to install LPG in the Rodeo. If you get this kit and it's fitted by one of the approved fitters, your warranty will not be affected. Check with your dealer and ask him to show you that the kit and fitting company he is using are approved by Holden. He will have the information on hand.