Are you having problems with your Toyota? Let our team of motoring experts keep you up to date with all of the latest Toyota issues & faults. We have gathered all of the most frequently asked questions and problems relating to the Toyota in one spot to help you decide if it's a smart buy.
Show all
We have passed some on to Toyota for their attention and response, and they have come back to us asking for the details of relevant owners and the dealers they have consulted so their Technical Services Department can deal directly with them in an effort to resolve their complaints. Specifically they would like to contact readers Jim Rogers of Boronia in Victoria and Mick Ryan of Niddrie, also in Victoria. If those two readers contact us at carsguide.com.au, quoting this announcement we will pass their details on to Toyota.
The FCAI guide to E10 compatibility indicates you can use E10 in your car and BP also says you could use E10 without a problem. But there is too little real world experience available yet to say for sure that it will be fine. At least for the short term your mechanic's advice to use Premium unleaded would seem to be prudent until we know more.
We have passed a number of these reports on to Toyota for their response and last week we received this comment from a Toyota spokesman: "Toyota acknowledges owners comments regarding the ATM light illuminating when towing heavy loads. We are currently investigating the issue. However, we wish to advise, the ATM light only indicates high oil temperature. Owners who experience this condition should follow the 'Owners Manual' instruction, as well as ensuring airflow to the radiator is not blocked."
We will be keen to hear the outcome. Since we reported the problem Chris Brown was having with his car a number of other owners have reported the same problem. While a leaking rear door seal can cause the problem, the location of the exhaust outlet below the rear of the vehicle is likely to be the main problem. Move the outlet and the problem is likely to go away.
While it took too long to resolve your complaint you should be congratulated for maintaining the pressure on Toyota until they did resolve the problem. Other owners frustrated by problems with their cars, whatever the make, should take note.
Don’t do it, get the wheel alignment done correctly. Whoever did the wheel alignment hasn’t adjusted the tie-rod ends correctly. You can remove the steering wheel, but unless it’s a full spline out it won’t line up anyway. When you replace the wheel you will find there will be a code showing a problem with the airbag and you will have to reset the code. That would be a problem.
The fuel consumption does appear to vary a lot, too much I would suggest, so I would definitely have the dealer check it. The knocking noise could indicate a faulty knock sensor.
Your experience of increased performance and increased fuel consumption on E10 is in line with what we've been told would happen, but the failure of a rubber component in the fuel tank is cause for concern. So too is the starting difficulty you had. Both of your cars are claimed to be E10 compatible, but like you I'm not convinced that E10 won't cause some issues on some cars.
When unloaded the tyres should be inflated to 200 kpa (29 psi) front and rear, but when loaded the recommended pressure is 200 kpa (29 psi) and the front and 220 kpa (32 psi) at the rear. If you open the driver's door you will find a sticker on the door pillar with the recommended tyre pressures, and you will also find it in the owner's manual.