Are you having problems with your Holden? Let our team of motoring experts keep you up to date with all of the latest Holden issues & faults. We have gathered all of the most frequently asked questions and problems relating to the Holden in one spot to help you decide if it's a smart buy.
Show all
You need to be able to demonstrate that the wear is not normal fair wear-and-tear, and that of course is always very hard to do. There is no benchmark for wear of this type. Perhaps you could check other similar Captivas for the same wear pattern and develop a case you could present to Holden. Other readers might like to tell us of their experience with the Captiva.
I would put my money on the Crank Angle Sensor, even though you are willing to rule it out. It does sound electrical and the CAS is often the culprit in these deals.
The VH was built in the days before we had unleaded fuel. In standard form the 202 cubic inch six had a compression ratio of 8.8:1, so it would have been running on the Super fuel of the day. Fitting an aftermarket head is probably going to increase the compression ratio, and you’ve got a sports cam, so I would tend to run it on 98-octane fuel, and it will need an additive like Flashlube of Valve Saver if you don’t have hardened valves and valve seats. If you don’t have those I would recommend you fit them in the rebuild, that way you could use unleaded fuel without an additive.
It does sound like a loose timing chain as the Holden dealer has suggested. We've had another report of a broken timing chain on an Alloytec engine and the result in that case was a badly damaged engine, so I would act quickly and have the chain checked and replaced if worn or loose.
You shouldn’t have any trouble with doing that.
It’s misfiring under load, and on both fuels, which suggests it’s electrical rather than fuel. Check the coil packs and make sure you’re getting a good, regular and strong spark.
The jury is out about E10 at the moment; it is supposed to be satisfactory for modern cars, but there are too many reports like yours that suggest that's not quite right. You could run the Barina on premium unleaded and not have a problem and that's probably the best thing to do if you are concerned about ethanol.
The presence of exhaust gases in the coolant suggests it's either a head gasket leak or perhaps a cracked head.
They are relatively common faults. Carmakers do make parts to be replaced rather than repaired, it's considered cheaper for all concerned if a mechanic simply has to pick up a new part and fit it instead of spending possibly hours repairing the old part. It means lower warranty costs for the carmaker, greater volume of work going through dealer workshops, and usually results in lower costs for the owner. It's impossible to say you will have more troubles in the future, but it's a fair bet that you will.