Mitsubishi Challenger Recall - Information & Updates

Cars are either being built worse -- or companies are getting better at detecting faults.a range of models made over the last 10 years replacing potentially deadly Takata airbags in 1.3 million cars in Australia. a second, airbag-related recall for the Priusreplacing potentially deadly Takata airbags in 1.3 million cars in Australia

The safety recall is to fix a fault that could see the powered seats' reclining lever stick in the operating position after use, allowing current to continue to flow to the seat motor. Mitsubishi says there is a risk the motor, seat cushion and surrounding parts could melt or burn."There have been two incidents recorded in Australia, with no injuries," Mitsubishi spokesperson Shayna Welsh says."There are 3,647 vehicles affected in Australia.  Customers need to take their vehicle to a dealership to be inspected, which should take around 20 mins, however, if the seat adjuster assembly needs to be replaced, this action will take up to two and a half hours."The recalled vehicles are the 2007-2013 Triton 4WD Double Cab and 2010-2013 Challenger 4WD models fitted with power front driver's and/or passenger's seat.Mitsubishi says that as a precaution until the owners have their vehicles inspected, they should make sure the reclining lever always returns to the central position after they have used it -- and whenever they leave the vehicle.All owners of affected vehicles have been contacted by mail sent to their last known address, and are asked to contact their nearest Mitsubishi service dealer to have their vehicle inspected and the seat assembly replaced if needed.Owners who believe their vehicle is in the affected range and who have not received a letter by today, September 27 -- or seek more information -- should call Mitsubishi on 1300 13 12 11 and select option 4, then select option 2.

Mitsubishi has issued a safety recall on a total of 20,405 vehicles from the 2011-2012 Triton and Challenger ranges. The recall is to fix a defective weld on the front suspension lower control arms that could fail -- making the vehicle become unstable and pull to the left or right while driving.The recall affects both 2WD and 4WD versions of the models, with 17540 Tritons and 2865 Challengers impacted in Australia.Mitsubishi says if the weld fails, the driver will notice their vehicle pulling off-centre -- which poses a safety concern for both the vehicle and other traffic. Owners are advised to drive conservatively to reduce shock load on the suspension until the defect is fixed.All owners have been mailed the recall notice at their last known address, and should contact their nearest Mitsubishi service centre to have the problem rectified. They can also call 1300 13 12 11, select option 2 and enter their post code to be directed to the nearest Dealer.Owners who have not received a letter by November 22 but believe their vehicle affected by the recall -- or who want further information -- should call 1300 13 12 11, select option 4, then select option 2.