Hyundai IX35 2012 Problems

If you’re lucky, the problem might be as simple as a blown fuse that controls these circuits. So that’s where to start checking. The instrument panel lights and rear fog lights in the Hyundai are on separate circuits, so you’ll need to locate both fuses. Start with the internal fuse box located low down on the dashboard near the steering column. The inside of the cover will have a map of which fuse does what, but don’t forget there’s also a second fuse box under the bonnet.

If the problem is not a blown fuse, or the fuse blows again once you’ve changed it, you’ll probably need to services of an auto electrician to figure out where the power is going and what’s the cause. A poor earth somewhere on the car or a short circuit are two likely culprits.

A poor earth is often the cause of this sort of misbehaviour and it’s a good place to start looking. Check the earthing points in the engine bay and around the area where the tail-lights are earthed in the cargo area.

You might need to lift some carpet or trim pieces, but when you find the earth points, make sure they’re tight and clean and not covered in corrosion. Don’t forget to check the tightness and cleanliness of the battery terminals, too.

Beyond that, these symptoms point to a problem with the car’s body computer which controls all these functions and many more.

When this computer starts to die, all sorts of weird and random flaws can occur. But try this first: Disconnect the battery of the car and let it sit overnight. Reconnect it next morning and keep a close eye on what happens. Sometimes this simple trick will reboot the body computer and normal service will be resumed. Best of all it’s free.

This was a huge problem for manufacturers back when turbo-diesels first started using Diesel Particulate Filters (DPF). The problems started when owners were using their diesel-powered vehicles just as they had their previous petrol cars. That is, for short, urban journeys where the exhaust system never got hot enough to perform a DPF regeneration (which is critical to the way these filters reduce tailpipe emissions).

To counter that, some manufacturers programmed the engine to dump extra fuel into the exhaust to get it hot enough for a DPF regeneration. Inevitably, however, sometimes some of that extra fuel found its way past the piston rings and into the engine's sump. And suddenly, there was more oil in the sump one day than had been there the previous day.

The problem there was that the diesel now in the sump was actually diluting the engine's lubricating oil, and that could lead to accelerated engine wear and bearing failure. The best solution – then and now – is to make sure you drive the vehicle at freeway speeds for at least an hour every three or four weeks. That will get things hot enough for the DPF to regenerate if it has to, and not rely on the extra diesel the computer will pour into the engine.

You could be looking at a specific DPF problem or maybe a software glitch that is messing up the regeneration, but if the level on the dipstick is rising, then I'd say that's your problem.

By all means you can try, but I doubt that you will have any success. The car is six years old, and the steering wheel is something that is subject to wear simply from being handled.

When an engine blows thick white (or bluish-white) smoke, it’s often a sign of internal engine wear. Some Hyundai engines have had problems with major engine components developing premature wear and causing similar problems to the ones you’ve experienced. But some Hyundai engines of this era also suffered problems with the EGR valve (exhaust gas regulation, part of the emissions control system) and that could lead to similar problems.

The best advice is to have the vehicle inspected for internal wear or any other problems that could be causing the smoking under load situation. This is pretty back to basics stuff and would include a compression test and leak-down test and should be well within the capabilities of any decent workshop. From there, you can make a more informed decision on whether to spend the money to have the car fixed, or cut your losses and move on.

It's also worth mentioning that Hyundai has been very pro-active in helping out owners who have experienced premature engine-wear problems, but the age of your car plays against this. It would be worth contacting Hyundai’s customer service division, however.

While I imagine that it's possible to modify the electronics to do what you want, I doubt it's as simple as you seem to think. To do it now on a 2012 isn't something I imagine Mazda would be interested in. Perhaps you could take it to an auto electrician and see if they could do it for you.

The 2.5-litre petrol engine in the CX-5 will give you the zip you want. If you need oomph for towing, go for the diesel.

The CX-5 is the better vehicle, but the Hyundai is likely to be cheaper and with much longer to run on the factory warranty.