Ford Focus: How to remove the radio

Pop out the side trim panel next to the centre console using a plastic trim removal tool, and then remove the plastic trim surrounding the gear shifter console. There is a T20 Torx bit holding the back of the shifter trim down, so remove that. Pop off the trim panel above the temperature and fan controls (housing the passenger airbag warning light), then disconnect the wiring connector for the passenger airbag warning light. Remove the four T20 Torx bits holding the fascia to the car, then put the car into Drive (or 2nd gear if a manual), pop up the gear shifter boot, then pop out the rest of the shifter and fan control plastic trim. Pop the radio and vent panel out by pulling on the opening under the hazard light button, then unplug the radio wiring.

The radio unit is held in by two T20 Torx bits.